Hi,
Iam using TMP102 device in my design. As an initial stage of testing i was trying to read the configuration register default values. Instead of getting 0x60,0xA0 im getting 0x17,0x70 values. I have checked the wavforms in oscilloscope, the data transfer my host master device(OMAP 3530). I am having a 1.8V to 3.3V level translator in between & I measured the waveform at the input of TMP102 only. ADD0 is connecting SDA line & i noted that master is not sending any ACK signal for the last data byte read(data byte 2).
Will it cause any problem.? I tried to write the default values in the cnfiguration register, but in that condition also, iam getting the value as 0x17 & 0x70 only.
Pls hel me in solving this.
Thanks & Regards,
V.Yuvaraj
ALL CONTENT AND MATERIALS ON THIS SITE ARE PROVIDED "AS IS". TI AND ITS RESPECTIVE SUPPLIERS MAKE NO REPRESENTATIONS ABOUT THE SUITABILITY OF THESE MATERIALS FOR ANY PURPOSE AND DISCLAIM ALL WARRANTIES AND CONDITIONS WITH REGARD TO THESE MATERIALS, INCLUDING BUT NOT LIMITED TO, ALL IMPLIED WARRANTIES AND CONDITIONS OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, TITLE AND NON-INFRINGEMENT OF ANY THIRD PARTY INTELLECTUAL PROPERTY RIGHT. NO LICENSE, EITHER EXPRESS OR IMPLIED, BY ESTOPPEL OR OTHERWISE, IS GRANTED BY TI. USE OF THE INFORMATION ON THIS SITE MAY REQUIRE A LICENSE FROM A THIRD PARTY, OR A LICENSE FROM TI.
Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Terms of Use of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Terms of Use of this site. TI and its suppliers reserve the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.